fbpx

laser problem if you can help me ..

11 years 8 months ago #408 by Excentric
Hello .. i have a problem with my new rgb :( ( any suggestions ? thanks ..

ES

Please Log in or Create an account to join the conversation.

11 years 8 months ago #409 by admin
Replied by admin on topic laser problem if you can help me ..
If your Fiesta is working with other laser system, the only problem is bad ILDA cable/connector. Check your laser manual, if it uses standard ILDA connector.

Michal

Please Log in or Create an account to join the conversation.

11 years 3 months ago #456 by ZeroWaitState
Definatly check your cabeling, i purchased a cable from kvant and the interlock pins were not shorted ( as they do this internally on thier projectors i believe) this caused me some problem initally as i have crap rgb from china an had a similar issue to what you mention.

Som projectors will not work if the correct pins are not shorted as per the ILDA spec.

Please Log in or Create an account to join the conversation.

11 years 1 month ago #490 by ZeroWaitState

quietlee wrote: Please can you give me the pinout of what pins should be shorted out to make this dot thing goaway as I have the same problem.

Thanks


this is a snip of a reply email from Dusan when i had this proble a year or so back

>>SNIP

Dear Ben

About ILDA cable, all our cables are tested so I thing that problem was other.
I thing that with pin 7 and 14 because in standard it is for Interlock but our lasers don't need it so this pins are conected directly together in our laser.
Our interlock is provided another. If the signal not going to laser than laser are not running so we don't need pin 7 and 14.
Please in attachment you will find description of our conection and standard conection like is recomended by Pangolin.
So please checkit.
So if ther was another problem Let me exactly where was problem according you.

Thanks a lot,
<< END SNIP

You may find that this will this will fix the problem as i found the cable supplied by Fiesta did not have these pins wired at all, which is fine if used on thier projectors but cab be problematic when used on other units.

If you go the the laserfx web site they have a pin out listing http://www.laserfx.com/Backstage.LaserF ... outs9.html

hope this helps you out, there is nothing more frustrating than having the toys and not being able to play with them.

Please Log in or Create an account to join the conversation.

Moderators: mystery
Time to create page: 0.509 seconds
Powered by Kunena Forum